Since 0.952 fresh, when the print is finish, and restart print , the start Gcode doesn't completely and printer has bad behaviour :
with Gcode start below, when restart print, printer doing Home (G28), and not down G1 Z15 F6000; bed and extruder heat start and wait temperature (Gcode print), and when the temperature is reached, extruder go to down but too down, in clash with bed !
Gcode start isn't done properly and it is a disaster…the homing in Gcode scripts doesn't properly ?
Octoprint GCODE scripts (start) :
M80 ; ATX ON
M177 ; Fan3 off
M106 S255 ; fan1 on
M150 R255 ; fan4 on
G28 ; Homing
G1 Z15 F6000 ; down extr
M106 S180 ; fan1 on xxpct
M150 R180 ; fan4 on xxpct
;M176 fan2 on
Gcode after jobs complete :
M150 R0 ; fan 4 off
M84 ; Stop printing
Doesn't this bug when cancel and restart print. it's only after finish print.
only reboot for restart with good behaviour.